|
NEW
Formulation!!!
Solution
VLM
The cleaning
power of Microsplitter infused into an organic
carrier material.
Probably
the most
advanced product of its type, SolutionVLM
takes Very Low Moisture ('VLM' or
'Dry') cleaning to a new level of efficiency!
Because
only very low levels of
moisture are employed:
- The risk of shrinkage is virtually eliminated.
- Carpets fitted by means of water-sensitive glue
are not a
problem.
- Other humidity-sensitive areas such as double
floors can be
cleaned without risk.
- Carpets can be walked on during and immediately
after
cleaning - no down-time!
Solution
VLM does
not contain detergents, so there is no sticky residue to
contribute to re-soiling - also because the granules do not adhere to
carpet fibres, they are much easier to remove at the final stage of the
clean.
Solution
VLM does
not contain optical brighteners it does not cause
yellowing.
Solution
VLM does not affect
treatments, such as Solugard® or Scotchgard®,
Solution
VLM does
offer safe, efficient cleaning without risk of wick-back as
well as a broad spectrum of stain and spot removal.
Solution
VLM can be applied on all water and colour-fast
surfaces
made of natural and synthetic fibres. Always pre-test carpet or surface
to be treated in an inconspicuous area before proceeding.
Sometimes, foam-building occurs during the cleaning
procedure. This is caused by shampoo or detergent residues that were
not properly rinsed out in prior cleaning. These detergent residues can
cause an increased re-soiling and re-appearance of stains and spots on
the floor. This effect will be reduced after several cleans with
Solution No. ONE.
Cleaning instructions:
- Thoroughly pre-vacuum carpet.
- Pre-treat heavily soiled areas lightly with Solution Carpet and
Upholstery Cleaner (Standard
or Natural as
appropriate).
- Turn container of Solution VLM for a few moments to ensure
that it is evenly moistened.
- Sprinkle the
granules onto
the carpet at the rate of approximately.
50-100 g/m², depending on the degree of soiling. This can
either be done by hand or machine.
- Brush granules into the carpet using a twin
contra-rotating
brush machine, brushing from several different directions to ensure
full treatment.
- Allow the granules to dry (15-30 minutes,
depending upon
condition). during this phase the granules, acting as natural sponges,
will absorb soil-laden moisture, resulting in a change of colour.
- When completely dry, remove granules using a
commercial-grade upright vacuum cleaner.
- Solution
VLM removes
a broad spectrum of stains and spots, including filtration
soiling in peripheral and door areas, grease, beverages, protein,
dispersion paints, mustard, oil, ketchup, etc. However, should any
spots or stains still be apparent, they should be treated with
specialist spotters from the solution range.Spots which cause
a fibre-colour-reaction, for example urine, coffee, etc.may not be
totally
treatable.
Technical Data:
Smell: typical
Appearance: yellow
Coverage: approx. 50 g/m²
Storage: in closed containers, frostfree, dry and cool.
Solution VLM - Safety Data Sheet
|
